What did you do to your Patrol today!

[MudRunnerTD]

Hold steady on purchasing Team NP
Its first two Dyno runs today kept blowing the hose off at the W2A Intercooler outlet side
Have raced across to Lilydale with two (2) of my original setup Norma T bolt style clamps that handled its first Dyno 2,000km ago.


Sent from my iPhone using Tapatalk

I used these on the GUIV running 28PSI and never had a problem with them

https://www.uniclamp.com.au/products...29c99014&_ss=r

[Bidja]

Been finishing off installing some gauges and bits in the top flap of center console GUIV, but out in came again to change e-locker switch... it gets easier

[10G]

Hey, that's woken my brain up. How hard is it to remove the stock radio? I might be doing that soon.

[Bidja]

Hey, that's woken my brain up. How hard is it to remove the stock radio? I might be doing that soon.

Will be putting it back together today, I will take some pics to show.

Only a couple of screw in the console to remove and then pull it towards u from top (removed).
Then 4 screws holding radio in place.
Always harder the first time.

[mudski]

Been finishing off installing some gauges and bits in the top flap of center console GUIV, but out in came again to change e-locker switch... it gets easier

Wait until you need to do a full dash removal for a new heater core. Done mine twice now, one for the heater core then the A/C evap went. Not a hard job, just time consuming.

[Bidja]

Wait until you need to do a full dash removal for a new heater core. Done mine twice now, one for the heater core then the A/C evap went. Not a hard job, just time consuming.

Remember seeing the pics (a pre trip job).
I started with just removing the tunnel full console to re-fix the gear shift boot and remove 16yrs of dog hair (fond memories of best mates).

[Bidja]

Cluster all hooked up and even works. haha
Main and Aux battery V_meters w/2xUSB chg ports each.
Auber type gauges w/pyro measuring air temps in hot/cold side FM cooler.
Switch E-locker + a secondary isolator rocker around side of console.

[BigRAWesty]

Finished wiring in all the lights.
I think I have enough..

Sent from my SM-S916B using Tapatalk

[Bidja]

Hey, that's woken my brain up. How hard is it to remove the stock radio? I might be doing that soon.

Check this post out may help mate:
https://www.nissanpatrol.com.au/foru...418#post846418

[gazq]

New (used) non-leaking vacuum pump 110 amp altenator installed.

Also upgraded the wiring to the battery with 185 amp rated wire that has a 125amp midi fuse on the battery and one for the altenator side. Basically ripped off the idea from the Qikazz website and made it myself for a lot less with some stuff I had laying around.

IMG_20240721_110424485_HDR.jpg
Even got fancy with nutserts instead of tek screws.

IMG_20240721_124725877_HDR.jpgIMG_20240721_130403843_HDR.jpg

You can see the turbo is off while I was waiting for a turbo to dump pipe gasket from MTQ to arrive.


IMG_20240721_130924827_HDR.jpg